Introduction
The Seaga S500, S400, and S300 VISI Coolers are advanced refrigeration units designed for storing and displaying beverages efficiently. This guide covers essential details for setup, maintenance, and resolving common issues.
Specifications
Physical Dimensions:
| Model | Height | Width | Depth | Shelves | Max Shelf Load |
| S300 | 120 cm | 60 cm | 65 cm | 3 | 35 kg |
| S400 | 150 cm | 70 cm | 70 cm | 4 | 40 kg |
| S500 | 180 cm | 80 cm | 80 cm | 5 | 40 kg |
Electrical Requirements:
- Voltage: 230V, Single Phase, 50 Hz
- Stabilizer: Optional (recommended in areas with voltage fluctuations)
Environmental Conditions:
- Operating Temperature: ≤40°C
- Relative Humidity: ≤45%
Installation
Steps for Setup:
- Unpack and Inspect:
- Placement:
- Power Connection:
Operating Instructions
- Load products vertically for efficient air circulation.
- Maintain a minimum clearance around the cooler.
- Avoid overloading shelves to prevent cooling inefficiencies.
- Monitor the temperature using the built-in thermostat.
Maintenance and Care
Preventive Maintenance Checklist:
- Clean the condenser every 15 days to ensure optimal cooling.
- Check for loose wiring connections and secure them as needed.
- Verify that the door gasket seals tightly to prevent air leakage.
Defrosting and Cleaning:
- Manually defrost if excessive frost builds up.
- Wipe the interior with a soft cloth dampened with warm water and baking soda. Avoid abrasive cleaners.
Troubleshooting
| Issue | Cause | Solution |
| Cooler not powering on | No power supply or loose connection | Check and secure connections; replace fuse. |
| Insufficient cooling | Door left open or gasket misalignment | Close the door, fix or replace the gasket. |
| Excessive noise | Uneven leveling or loose components | Level the cooler; tighten screws and fasteners. |
| Lights not working | Bulb or switch failure | Replace the bulb or switch as necessary. |
For more details, access the full manual here.
For immediate support, contact [email protected] or call +91 (1276) 268122.